SYSTEM MESSAGE: WELCOME TO THE MANTiS DIRECTORY LISTING. IF IT IS YOUR FIRST VISIT, CHECK OUT THE FAQ BEFORE POSTING.
MEMBERS: 6 | THREADS: 20 | POSTS: 70  ·  NEWEST: BOOT_SECTOR

MODEL M — REPLACING THE RIVETS WITHOUT LOSING THE CLICK

POSTED BY KBDWARRIOR ON 10-26-2026 08:15 PM

The IBM Model M is held together by plastic rivets that get brittle and snap off after 30 years. Mine had seven of them broken on the left side. The barrel frame was separating from the backplate, the membrane was no longer held tight, and the click on the left shift was gone.

Three repair paths people use:

1. Drill out the old rivet stubs, tap the barrel for 4-40 screws, bolt the barrel frame back to the backplate. Cleanest. Documented in the original IBM service manual.

2. Replacement plastic rivets from Unicomp. Cheap, original-spec, but the new rivets can be just as brittle as the old ones.

3. Double-sided foam tape along the broken barrel. Holds for years, does not damage the membrane, fully reversible. The quick-and-dirty fix.

I went with the screws. Took about 90 minutes. The click is back. Membrane is tight. Photographed the whole process if anyone wants a walkthrough.

// POSTS

The screws method is the cleanest. Drill out the old rivet, tap the barrel for 4-40, screw in a 4-40 stainless. The original IBM service manual actually documents this — it is the field-repair procedure. New plastic rivets from Unicomp are the OEM path but the new rivets are just as brittle as the old ones.
POSTED BY BOOT_SECTOR ON 10-26-2026 11:05 PM
Or you can just leave the broken rivet and use a thin strip of double-sided foam tape. Holds for years, does not damage the membrane, fully reversible. The quick-and-dirty fix. I have a 1986 Model M that has been held together with foam tape for five years now, no issues.
POSTED BY PLAYER1 ON 10-27-2026 08:33 AM