MODEL M — REPLACING THE RIVETS WITHOUT LOSING THE CLICK
The IBM Model M is held together by plastic rivets that get brittle and snap off after 30 years. Mine had seven of them broken on the left side. The barrel frame was separating from the backplate, the membrane was no longer held tight, and the click on the left shift was gone.
Three repair paths people use:
1. Drill out the old rivet stubs, tap the barrel for 4-40 screws, bolt the barrel frame back to the backplate. Cleanest. Documented in the original IBM service manual.
2. Replacement plastic rivets from Unicomp. Cheap, original-spec, but the new rivets can be just as brittle as the old ones.
3. Double-sided foam tape along the broken barrel. Holds for years, does not damage the membrane, fully reversible. The quick-and-dirty fix.
I went with the screws. Took about 90 minutes. The click is back. Membrane is tight. Photographed the whole process if anyone wants a walkthrough.